Gatco 783 Mounting Bracket for Recessed Paper Holders

SO you've got the hole cut out to fit your tp dispenser. You've got to put the tp dispenser screws through the back of the dispenser. Force the screws into the slots on the bracket to make threads. Do not tighten more than a few threads because you'll never get the whole rig into the wall. Then put the bracket into the hole DIAGONALLY with the tp dispenser loosely attached. Carefully turn the whole deal until it fits the right way. Then jiggle it to make sure the spring is properly seated. Using a motoroized screw gun SLOWLY tighten the screws. Make minor alignment adjustments as you tighten. These are the most instructions for this you will see anywhere, including the packaging.

If you don't have an old mounting bracket from an existing recessed holder, you will need to buy this one. If using an existing holder, from a different brand, new holes will need to be drilled. Using Gatco's hardware for mounting a Gatco TP holder is really plug-n-play. Maybe a little pricey, but it does a nice job.

Buy Gatco 783 Mounting Bracket for Recessed Paper Holders Now

Stretch the spring if it does not reach the stud or drywall. Toilet roll holder is installed nice and tight :)

Read Best Reviews of Gatco 783 Mounting Bracket for Recessed Paper Holders Here

This device may work fine if you happen to have a standard wall on four-inch studs set perfectly 16 inches apart but my bath is on the outside wall and for some reason design of the house I guess -there was about 10 inches of vacant space to the wall beyond the 2x4 stud. Obviously, the little tookie spring was of no use. I measured exactly between two 16 inch studs and my stud finder didn't show another stud, but when I began cutting out the draw wall bingo a stud exactly where it shouldn't be. I remeasured between the 8 inch gap and was able to wedge the wing of the holder under the stud and dry wall, then screw in an extension piece of wood to the other stud where I got the device to hold in place -then I tightened the two screws to the bracket behind the wall and that snugged it up securely. What should have been a 30 minute job ended up being a two hour job. The bracket was useful the spring a throw away. This thing just has no options for mounting and you may very well end up having to fabricate something that works for you. But the holder and bracket was well worth it to toss an old stand up toilet paper holder that just served to catch dust and rusted ...

Want Gatco 783 Mounting Bracket for Recessed Paper Holders Discount?

The item worked great without any holes having to be put into the wall or any drilling not required, just basic tools

Save 26% Off